Home / Plymouth / Barracuda / 1972 Plymouth Barracuda

1972 Plymouth Barracuda For Sale

  • viewed Viewed 17,119 Times

1972 Plymouth Barracuda, Lemon Twist Yellow

1972 Plymouth Barracuda. 72 Barracuda 440 AT Manual Steer.

Take a close look! Very fun car and a real head turner! Looks good, sounds great, and runs great. Check out the videos I’ve posted to Youtube and Facebook, links below. Nice cruiser, not a show car or race car. Needs to be finished by someone with time and attention to detail. 

Put together in 2000, only has ~3,000 miles on it since all the work below done. 

Short Block
• ’70 440 .030” over
• Steel Crank std mains/.010” rods
• Forged 11.5:1 pistons
• Truroller timing chain
• MP 296°/.557 Solid Purple Shaft
• Windage tray
• Moroso deep pan 
• Hemi oil pickup 
• NEEDS crack in bottom of pan fixed. Seeps oil

• Gasket matched intake side
• Crane gold roller rockers
• Cromoly push rods
• MP Cast Polished Valve Covers
• 2.08ex/1.88in stainless valves
• Double springs

• 727 
• Dynamic 8” 3800 
• Cheetah Manual reverse pattern valve body
• Urethane trans mount
• Deep pan
• B&M reverse pattern shifter

• 70 Six Pak 3x2, Alum factory Edelbrock intake/air cleaner/etc
• Mallory fuel pump
• 16 gal fuel cell in trunk
• ½” alum line with return
• Vac bypass regulator
• Braided lines and aircraft fittings 

• 11” cop car rotors in front
• 11” drums in back
• Stainless brake lines
• Manual master cylinder

• Urethane graphite bushings
• Hemi Torsion Bars
• Powder coated suspension components
• Super Stock rear leaf springs

Rear End
• 4.10 8-3/4
• Dana clutch type posi
• Springs moved in ¾”per side
• 3” studs
• Powder coated housing

• Jacobs Coil
• Factory Distributor with light springs 

• TTI 2” Nickel plated headers, 3-1/2” collector
• 3-1/2 into 3” Dr Gas X pipe
• 3” 2 chamber flowmasters
• 3” TT Over the axle tailpipes
• NEEDS 3” TTI Cuda exhaust tips

• Body work done in ‘99
• New ¼’s, trunk pan, wheel houses 
• Base/Clear Lemon Twist
• Has a couple minor spots I’ll show you

• Rechromed bumpers (2003)
• New door handle (2000)
• New marker lights (2000)
• New chrome mirrors (2012)
• New Antenna (2012)
• Aftermarket wing similar to 70 style
• NOS grill and lower

• Scat buckets
• Recovered back seats
• New interior panels (2012) not installed
• Powder coated trim, dash frame 
• Aluminum sheet between trunk and pass compartment

• 15x 10 Rodlites rear, BFG 305/50/15 drag radials
• 15 x 5 Rodlites front 

• Window mechanisms rebuilt
• Wiper Motor
• Wiper arms
• Blower motor
• Seat belts
• Interior finished
• Spot near the pass side rear tail panel has some rust
• Small dent in ¼ on drivers side near the upper body line
• Chip on corner of rear bumper chrome
• Crack in oil pan, Moroso factory defect. 
• Interior needs finished
• Instrument cluster needs restored

I’ve had it to the track once. It ran a 12.46 @109 through the exhaust, on street tires.
Originally a 318 A/C AT PS car. Original color was a metallic green. Titled in CT as a 340 car, not a 340 car. 
Runs and drives, sold as is, where is. Currently registered and insured. I don’t need to listen to tire kickers or critics; If you don't like it, move on. 
Asking $24,900
Prefer cash deal, but specific trades considered:
1. Dodge 6 spd Cummins 2010+
2. Challenger R/T Scat Pack 6 spd 2015+

Click to see Seller VIDEO

Click to see Seller VIDEO

Click to see Seller VIDEO

Click to see Seller VIDEO

Click to see Seller VIDEO

Click to see Seller VIDEO

Click to see Seller VIDEO

Click to see Seller VIDEO

Click to see Seller VIDEO

Click to see Seller VIDEO


For Sale By Owner

Vehicle is Sold

New Fairfield, CT 06812
Auto Transport Quote

How much to insure this Plymouth Barracuda?
Enter Zip Code:

How much will it cost to insure a Plymouth Barracuda?
Enter Zip Code:

Other Plymouth Barracuda Listings

View all Barracuda Cars for Sale

Year, Make, and Model Price Mileage Location